multisim出现timestep too small

冬青

In smaller circuits this error is generally due to a mistake in wiring or connecting components, so this must be checked first.

If the wiring has been validated in the circuit follow these steps:
1.Select Simulation » Interactive Simulation Settings
2.Under Initial conditions select Set to zero
3.Click the OK button
Check to see if the simulation now works. If not:
4.Select Simulation » Interactive Simulation Settings
5.Change Maximum Time Step (TMAX) from 1e-005 to 1e-003
6.Click the OK button
Check to see if the simulation now works. If not:
7.Select Simulation » Interactive Simulation Settings
8.Select the Analysis Options tab
9.Select the Use Custom Setting radio button and click on the Customize button
10.Select the Global tab
11.Set Relative Error Tolerance [RELTOL] to 0.01
12.Set Shunt resistance from analog nodes to ground [RSHUNT] to 1e+9
13.Select the Transient tab
14.Set Integration Method [METHOD] to Gear
15.Click the OK button
16.Click the OK button
In Multisim 10.x and higher the Convergence Assistant conveniently tries to fix this error for you.